The Effect of Thermo-Mechanical Processing on the Microstructure and Mechanical Properties of Modified SIMA Treated Al-7Si Alloy
IR@NML: CSIR-National Metallurgical Laboratory, Jamshedpur
View Archive InfoField | Value | |
Title |
The Effect of Thermo-Mechanical Processing on the Microstructure and Mechanical Properties of Modified SIMA Treated Al-7Si Alloy
|
|
Creator |
Choudhary, C
Sahoo, K L Mandal, D |
|
Subject |
Mechanical Engineering
|
|
Description |
The effect of holding time and temperature in the Modified Strain Induced Melt Activation process on microstructure and mechanical properties of Al -7 wt% Si alloy was investigated. Al -7 wt% Si alloy was prepared through melting and casting route. The alloy was homogenized at 540 ℃ for 6 h. The plate was deformed 40 and 60% by warm rolling followed by air cooling. The deformed samples were heat treated for different temp. (585, 595 and 605 ℃) and time (10, 30 and 60 min). The microstructure and mechanical properties of Modified SIMA treated samples were evaluated and compared with as-cast samples. It is observed that with increasing isothermal holding temperature and time during Modified SIMA process, the mechanical properties such as yield strength , ultimate tensile strength and hardness are increased but percentage of elongation decreased. The better combination of mechanical properties was obtained when 60% deformed alloy was isothermally hold at temperature 585 ℃ for 30 min.
|
|
Publisher |
Springer
|
|
Date |
2019
|
|
Type |
Article
PeerReviewed |
|
Relation |
https://www.springerprofessional.de/en/the-effect-of-thermo-mechanical-processing-on-the-microstructure/16485556
http://eprints.nmlindia.org/7985/ |
|
Identifier |
Choudhary, C and Sahoo, K L and Mandal, D (2019) The Effect of Thermo-Mechanical Processing on the Microstructure and Mechanical Properties of Modified SIMA Treated Al-7Si Alloy. Light Metals . pp. 241-249.
|
|