Narrow gap welding of low alloy and austenitic stainless steels using different Inconel alloys: comparison of microstructure and properties
IR@NML: CSIR-National Metallurgical Laboratory, Jamshedpur
View Archive InfoField | Value | |
Title |
Narrow gap welding of low alloy and austenitic stainless steels using different Inconel alloys: comparison of microstructure and properties
|
|
Creator |
Ravikiran, K
Das, Goutam Kumar, Suranjit Singh, PK Sivaprasad, K Ghosh, M |
|
Subject |
Structural Properties
|
|
Description |
In the present investigation, SA508 low alloy steel and 304LN austenitic stainless steel were joined by
hot wire narrow gap gas tungsten arc welding. Inconel 82 and 52 were used as filler alloys. Evaluation
of microstructure, micro-hardness, and tensile strength through in situ test in scanning electron
microscope were attempted for the welded assemblies. Low alloy steel consisted of a heat affected zone
adjacent to interface. Athin layer of martensite and Type-I boundary were revealed near the fusion
boundary between low alloy steel and weld metal. Micro-hardness distribution showed a peak near the
fusion boundary between low alloy steel and filler alloy owing to the presence of lath martensite, Type-
I boundary, and complex alloy carbides. The micro-hardness was further dropped within the filler
alloy. During the in situ tensile test, deformation was confined within the filler alloy, as it was the
weakest link across the fusion boundary. It was revealed that the joint produced with Inconel 82 filler
alloy has a better mechanical strength than the assembly fabricated with Inconel 52 filler alloy. Inferior
quality of the latter was attributed to the relatively coarser grain structure and the presence of larger
alloy carbides within filler alloy when compared with the former. Improved strength of the weld with
Inconel 82 filler alloy was further endorsed by the lower slip distance for dislocation movement and
higher strain hardening rate in comparison to the weld fabricated with Inconel 52 filler alloy.
|
|
Publisher |
IoP Publishing
|
|
Date |
2019-07-03
|
|
Type |
Article
NonPeerReviewed |
|
Format |
application/pdf
|
|
Identifier |
http://eprints.nmlindia.org/8085/1/MRE_2019.pdf
Ravikiran, K and Das, Goutam and Kumar, Suranjit and Singh, PK and Sivaprasad, K and Ghosh, M (2019) Narrow gap welding of low alloy and austenitic stainless steels using different Inconel alloys: comparison of microstructure and properties. Materials Research Express, 6(9) (IF-1.449). |
|
Relation |
https://doi.org/10.1088/2053-1591/ab2be2
http://eprints.nmlindia.org/8085/ |
|