A methodology for designing cutting drum of surface miner to achieve production of desired chip size
IR@CIMFR: CSIR-Central Institute of Mining and Fuel Research, Dhanbad
View Archive Info| Field | Value | |
| Title |
A methodology for designing cutting drum of surface miner to achieve production of desired chip size
|
|
| Creator |
Prakash, A.
Singh, K.B. |
|
| Subject |
Mine Subsidence
|
|
| Description |
The size of coal chips, produced during coal cutting operations, is of prime importance from the viewpoint of feed size desired by power plants. Proper chip size in cutting can eliminate primary crushing and in-turn save energy. Achieving a designated size of chip is intimately linked with the drum design inter alia the wrap angle, line spacing of picks and pick size. Operating parameters namely cutting speed and drum speed also influence the output. Considering the increased need to produce a sized product for cost-effective mining, a design methodology was developed to achieve a required chip size for surface miners with a middle drum configuration. Various pick, drum and operational parameters were taken into account for the development of drum design, namely drum width, drum diameter, pick size, clearance angle, rake angle, cutting angle, lacing pattern, angle of wrap, depth of cut, indented depth of cut and pick spacing. Limiting factors for drum design such as the number of picks, pick temperature, strength of pick, depth of cut and dust generation were discussed. A new drum configuration for achieving 100 mm chip size was validated which showed close agreement with the output produced using 2200SM model surface miner.
|
|
| Publisher |
springer
|
|
| Date |
2020-12
|
|
| Type |
Article
PeerReviewed |
|
| Relation |
https://doi.org/10.1007/s12046-020-01387-1
http://cimfr.csircentral.net/2213/ |
|
| Identifier |
Prakash, A. and Singh, K.B. (2020) A methodology for designing cutting drum of surface miner to achieve production of desired chip size. Sādhanā, 45 (1). ISSN 0256-2499
|
|