Comparison of bolted joints with two different clearance types
IR@NISCAIR: CSIR-NISCAIR, New Delhi - ONLINE PERIODICALS REPOSITORY (NOPR)
View Archive InfoField | Value | |
Creator |
Esendemir, Ümran
Öndürücü, Ayşe |
|
Date |
2011-10-18T10:34:01Z
2011-10-18T10:34:01Z 2011-08 |
|
Identifier |
0975-1017 (Online); 0971-4588 (Print)
http://hdl.handle.net/123456789/12894 |
|
Description |
283-292
In this study, bearing strengths of bolted joints with different clearances are compared. Woven-glass-epoxy prepreg composites are tested under two different bolt-bearing conditions. The geometry of the samples for bolted joints is suitably varied in order to find the limit for width-to-diameter (<i style="">W</i>/<i style="">d</i>) and edge distance-to-diameter ratios (<i style="">E</i>/<i style="">d</i>), which are necessary to avoid unsafe failure modes. Damage progression is examined using scanning electron microscope (SEM) on specimens with mixed (bearing+net tension) mode for different percentages of their ultimate failure load. It is observed that the clearance between the bolt and hole has an important influence on the failure load of mechanically fastened joints. |
|
Language |
en_US
|
|
Publisher |
NISCAIR-CSIR, India
|
|
Rights |
<img src='http://nopr.niscair.res.in/image/cc-license-sml.png'> <a href='http://creativecommons.org/licenses/by-nc-nd/2.5/in' target='_blank'>CC Attribution-Noncommercial-No Derivative Works 2.5 India</a>
|
|
Source |
IJEMS Vol.18(4) [August 2011]
|
|
Subject |
Bolted-joints
Failure analysis Scanning electron microscopy (SEM) |
|
Title |
Comparison of bolted joints with two different clearance types
|
|
Type |
Article
|
|